1. MOUNTING
3
For replacement of FE-680/FE-680T
You can replace FE-680/FE-680T with FE-800, using the optional Front Fixing Panel
kit OP12-1.
Front Fixing Panel OP12-1 (code no.: 001-273-660)
1. Remove FE-680/FE-680T from
mounting location.
2. Attach the front fixing panel to the
display unit from the front side with
binding head screws (M5×12).
3. Set the display unit to the original
cutout then fasten the display unit
as shown in the right figure.
1.1.4 Desktop mounting
The display unit can be mounted on a desktop using the optional hanger. See the out-
line drawing for details.
Bracket Assembly with Knobs (Type: OP26-8, Code no.: 000-016-313-00)
1. Remove the hanger mounting plate from the hanger assembly.
2. Fasten the hanger mounting plate
to the display unit from the left
side and right side with four bind-
ing head screws (M5×12).
No. Name Type Code no. Qty Remarks
1 Binding head screw M5×12 SUS304 000-171-999-10 4
2 Front fixing panel 12-005-1131-0 100-391-660-10 1
3 Hexagonal head bolt M8×35 SUS304 000-164-170-10 4
4 Spring washer M8 SUS304 000-167-410-10 4
5 Flat washer M8 SUS304 000-167-464-10 8
6 Hexagonal nut M8 SUS304 000-167-479-10 8
Name Type Code No. Qty
Self-tapping screw 5×20 000-171-997-10 4
Binding head screw M5×12 000-171-999-10 4
Hanger assy. OP26-8-1 001-081-920-00 1
Mounting plate
FE-8010
w/Front
fixing panel
Hex nutHex nut
Spring washerSpring washer
Flat washerFlat washer
Hex boltHex bolt
Rear side
of FE-8010
Hanger
mounting
plate
(left side)
Binding
head screw
(M5×12)
To Next Page
Loading...
