1. MOUNTING
4
3. Make a four pilot holes for self-tapping screws (φ5×20) in the mounting location.
4. Fix the hanger to the mounting location with four self-tapping screws (φ5×20).
5. Insert a washer to each knob (right and left) and fix the washer to the display unit
loosely.
6. Set the display unit to the hanger.
7. Tighten the knobs to fasten the hanger to the display unit.
8. Set a cosmetic cap to each fixing hole on the front panel. (See below "How to set
the cosmetic cap".)
How to set the cosmetic cap
Set a cosmetic cap to each fixing hole on the front panel as shown in the figure below.
260 ± 5 (10.24”)
288 ± 5 (11.34”)
240 (9.45”)
279 ± 5 (10.98”)
51 ± 5 (2.01”)
149 (5.87”)
91 (3.58”)
240 (9.45”)
Fixing hole (4-ø7)
190 ± 0.5 (7.48”)
75 ± 0.5 (2.95”)
40 (1.57”)
Set cosmetic cap to hole so cap is flush with panel.
To Next Page
Loading...
