Furuno FE-800 - How to Set the Ethernet

3. ADJUSTMENTS
22
3.5 How to Set the Ethernet
To set up the Ethernet for the LAN setting, select [I/O] → [Ethernet] on the [Service
Menu],
Menu Contents
[Navigation] Set the destination terminal.
• [DEST IP Address]: Set IP address of the destination termi-
nal. Available range: 239.192.0.1 to 239.192.0.64.
Note: The IP address must be within the available range to
comply with the IEC standards.
• [DEST Port]: Set the port of the destination terminal.
• [Data Source]: Set the source data.
• [Error Counter]: Show the LAN error log.
[Management Profile] Set the Management Profile.
• [Management Profile]: Set [OFF] for normal use. Set [ON] to
activate Management Profile.
• [DEST IP Address]: Set the IP address of the Management
Profile.
• [DEST Port]: Set the port of the Management Profile.
[Data Recorder] Set the Data recording software.
• [DEST IP Address]: Set the IP address of the Data recording
software.
• [DEST Port]: Set the port of the Data recording software.
I/O
Port1 ►
Port4 ►
Port Monitor ►
Ethernet ►
Ethernet
Navigation ►
Management Profile ►
Data Recorder ►