Furuno FE-800 - Advanced Display and Data Features

2. WIRING
17
3. Slide the cable gland, the gasket and the flat washers onto the cable as shown
below.
4. For the cable connected to transceiver unit, push the flat washer against the ar-
mor. Then trim the armor so that it does not extend past the flat washers, then
pass the cable through the cable entrance.
5. Tighten the cable glands with the hook spanner wrench.
Note: Use the wrench of the correct size. If you do not have the hook spanner
wrench, contact our dealer.
6. Connect the cables to terminal inside.
7. Close the top cover.
Grounding
Shorten the ground wire as much as possi-
ble.
Note 1: Ground the equipment to prevent
mutual interference.
Note 2: Use “closed-type” lugs to make the
ground connection at the display unit and the
matching box. Do not use an “open-type”
lugs.
GasketGasket
Cable glandCable gland
Cut and trim the armor.
Outer sheath
Inner
sheath
Flat washerFlat washer
Side: Transducer (2RNCT-SB 2C×1.4)Side: Transceiver unit (DPYCYSLA-2.5)
GasketGasket
Cable glandCable gland
Flat washerFlat washer
SheathSheath
From TransducerFrom Transceiver unit
Connect the cable from transceiver unit.
(2a: Ground wire)
1a
1a
2a
2a
3a
3a
1T
1T
2T
2T
3T
3T
Connect the cable from transducer.
(2T: Ground wire)
Ground point