Furuno FE-800 - How to Use the Function Key; How to Output to External Equipment

1. OPERATION
14
1.12 How to Use the Function Key
The function key can store and recall a preset location in the menu. You can recall the function by
pressing the FUNC key.
To store a function
1. Navigate the menu to the function you wish to store.
2. Press and hold the FUNC key to store the menu function. A small asterisk “*” will appear next
to the menu item when it is stored.
In the example below, [Manual GAIN] is stored to the FUNC key.
3. Release the FUNC key after the asterisk “*” appears.
4. Press the DISP key to return to the main display.
1.13 How to Output to External Equipment
The FE-800 can output depth information from one transceiver to external equipment, such as
ECDIS. To select the transceiver which will output to the external equipment, do the following:
1. Press the MENU/ESC key to open the Main menu.
2. Select [Output Depth] using  or , then press the ENT key.
3. Select [FORE] or [AFT] as appropriate, then press the ENT key.
The selected transceiver is highlighted as shown in the figure below.
4. Press the MENU/ESC key once to close the menu.
Menu item stored
to function key.
Transceiver selected for external output
is highlighted with green arrows.