Furuno FE-800 - How to Display the Alert Log26

2. SYSTEM MENU
26
2.7.2 How to display the alert log
The [Alert Log] tracks all alerts.
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [Alert] using  or , then press the ENT key.
4. Select [Alert Log] using  or , then press the ENT key.
Note: The above example shows alerts which are output under Alert I/F2 settings. The alert
ID differs depending on the alert format selected at installation. To change the alert format,
consult a FURUNO technician.
For more information about alert codes and meanings, see "ALERT
MESSAGES" on page AP-7.
5. To change pages, use  or .
6. Press the DISP key to close the open menus.