Furuno FE-800 - Dimmer, System Info, and User Reset

2. SYSTEM MENU
35
2.13 How to Adjust the Dimmer from External Equip-
ment
To change the dimmer settings from external equipment, do the following:
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [Remote Dimmer] using  or , then press the ENT key.
4. Select [ON]  or , then press the ENT key.
5. Press [DISP] key to close the menu.
Note: When [Dimmer Mode] in the [System] menu is set to [FE-800], the menu is not available.
To use this function, contact your local dealer.
2.14 System Information
The system information display shows information about your FE-800 unit and the transceiver(s)
connected to it. The figure below is an example of the information screen.
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [Information] using  or , then press the ENT key. A confirmation pop-up window will
appear.
4. Select [FE-8010], [FE-8020 No.1] or [FE-8020 No.2] as appropriate using  or , then press
the ENT key.
5. Press the DISP key to close the open menus.
2.15 User Reset
You can restore the factory default settings using this menu.
1. Press the MENU/ESC key to open the Main menu.
2. Select [System] using  or , then press the ENT key.
3. Select [User Reset] using  or , then press the ENT key. A confirmation pop-
up window will appear.
4. Select [YES] or [NO] as appropriate using  or , then press the ENT key.
5. Press the MENU/ESC key twice to close the menu.
Equipment’s unique
serial number
Software program
and version number