Furuno FE-800 - Transducer and Display Operations

1. OPERATION
19
1.20 How to Change the Colour Scheme
You can change the colour scheme of the display as follows:
1. Press the MENU/ESC key to open the Main menu.
2. Select [Display] using  or , then press the ENT key.
3. Select [Colour] using  or , then press the ENT key. This will open a
pop-up window.
4. Select the colour scheme using  or , then press ENT to apply the setting
and close the pop-up window. The available options are shown in the figure to the right.
5. Press the MENU/ESC key twice to close the menu.
1.21 Dual Transducer Operations
1.21.1 How to switch between displayed transducers
When there are two transducers connected, you may change the manner in which the echoes are
displayed on-screen.
1. Press the MENU/ESC key to open the Main menu.
2. Select [Display] using  or , then press the ENT key.
3. Select [Echo] using  or , then press the ENT key. The pop-up window
shown to the right appears.
4. Select [FORE], [AFT] or [DUAL] as appropriate.
5. Press the DISP key to close the menus.
1.21.2 How to change the displayed depth
When there are two transducers connected and the transducer display setting is [FORE] or [AFT]
(see section 1.21.1), you may change the transducer used to display depth information.
Note 1: When the displayed transducer setting is set to [DUAL], this menu function is not
available.
Colour scheme Background Colour Text Colour
Amber Black White
Black Black White
Blue Blue White
White White Black
FORE AFT
DUAL