Furuno FE-800 - How to Change the Unit of Measurement; How to Select the Displayed Course

1. OPERATION
18
1.18 How to Change the Unit of Measurement
You can change the displayed unit of measurement for depth and speed using the following
procedure.
1. Press the MENU/ESC key to open the Main menu.
2. Select [Display] using  or , then press the ENT key.
3. Select [Unit] using  or , then press the ENT key. This will open the
[Unit] pop-up window.
4. Select the [Depth] or [Speed] using  or , then press ENT to open the
settings pop-up window. The available options are shown in the table below.
5. Press the MENU/ESC key three times to close the menu.
1.19 How to Select the Displayed Course
You can select a course reference, true or magnetic.
1. Press the MENU/ESC key to open the Main menu.
2. Select [Display] using  or , then press the ENT key.
3. Select [Course] using  or , then press the ENT key. This will open
a pop-up window.
4. Select the course display using  or , then press ENT to apply the
setting. The available options are [True] and [Magnetic].
5. Press the MENU/ESC key twice to close the menu.
Number Description
1 Currently displayed time setting.
[UTC]: Coordinated Universal Time.
[Local]: Time with UTC difference calculated.
[Time]: Unit’s internal clock time.
2 When the external time source is unavailable, a “*” appears to the left of the time.
If [Time Adjust ] is set to Internal, the color changes according to the setting se-
lected at section 1.20.
3 Currently viewed page. Data is listed in order from newest to oldest.
Item Unit
Depth m (meters)
ft (feet)
Speed kn (knots)
MPH (Miles Per Hour)
km/h (Kilometers Per Hour)