CAUTIOCAUTION
Handle the LCD carefully.
The LCD is made of glass, which can
cause injury if broken.
Do not transmit with the transducer
out of water.
Damage to the transducer can result.
Properly adjust the gain.
Too little gain gives no picture. Too much
gain shows excessive noise on the
picture. Using the depth data for naviga-
tion when the gain is incorrectly set can
lead to a dangerous situation.
The data presented by this equipment
is intended as a source of navigation
information.
The prudent navigator never relies
exclusively on any one source of naviga-
tion information, for safety of vessel and
crew.
CAUTIOCAUTION
Too high Correct Too low
Name: Warning Label 1
Type: 86-003-1011-3
Code No.: 100-236-233
Warning Label(s)
Warning label(s) is(are) attached to the
equipment. Do not remove the label(s). If a
label is missing or damaged, contact a
FURUNO agent or dealer about replacement.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
About the TFT LCD
The TFT LCD is constructed
using the latest LCD techniques
and uses 99.99% of its pixels.
The remaining 0.01% may drop
out or blink, however this is not
an indication of malfunction.
Observe the following compass
safe distances to prevent
magentic compass deviation:
The use of two transceivers with
the same frequency will result in
interference.
Standard
Compass
Steering
Compass
Display Unit
FE-8010
0.75 m
0.50 m
1.50 m
0.95 m
0.80 m
0.50 m
0.65 m
0.40 m
Transceiver Unit
FE-8020
Matching Box
MB-502
Matching Box
MB-504
When fitting more than one transceiver,
ensure the frequencies are different.
To Next Page
Loading...
