4. GENERAL SETUP
4-9
4.14 How to Set the Timeouts
A timeout determines the number of minutes the radio should keep a given screen dis-
played before it restores the standby display, if no radio operation is detected. There
are three types of screens for which you can set a timeout: menu, DSC non-distress,
and DSC distress. Set the timeout for these screens as follows:
1. Long-press the CALL/MENU key to show the [Setup Menu].
2. Use the CH knob to select [DSC Setup] then press the [SELECT] soft key.
3. Use the CH knob to select [No Act Timer on Menu], [No Act Timer on DSC] or [No
Act Timer on DIST] as appropriate then press the [SELECT] soft key. For exam-
ple, select [No Act Timer on Menu]. (The choices for each menu are the same.)
No Act Timer on Menu: Set the number of minutes to keep a menu screen dis-
played before the standby screen is restored, if there is no radio operation.No Act
Timer on DSC: Set the number of minutes to wait before the standby screen is
restored, if there is no radio operation after a DSC non-distress message is re-
ceived.No Act Timer on DIST: Set the number of minutes to wait before the
standby screen is restored, if there is no radio operation after a DSC distress mes-
sage is received.
4. Use the CH knob to select the number of minutes desired (1, 2, 3, 4, 5, 10, 15, 20)
or [OFF] then press the [ENT] soft key. [OFF] keeps a screen displayed until radio
operation is detected.
5. Press the [QUIT] soft key several times to close the menu and return to radio op-
eration.
o Act Timer on en
ENT
min
min
min
min
min
min
o Act Timer on en
ENT
To Next Page
Loading...
