2. OPERATION
2-28
2.23 How to Off-center the Display
You can off-center your ship position to expand the view field without selecting a larger
range scale. The display can be off-centered manually, or automatically according to
speed of the ship.
Note: Off-centering is not available in the true motion mode.
2.23.1 How to select the off-center mode
1. Press the MENU key to open the menu.
2. Press or to select [Display], then press the ENTER key.
3. Press or to select [Off-center mode], then press the ENTER key.
4. Press or to select [Manual] or [Custom] then press the ENTER key. Press
the ENTER key again to change between on and off.
5. Press the MENU key to close the menu.
2.23.2 How to off-center the display
The off-center features shifts own position according to the off-center mode selected.
The mode selected from the menu appears at top left corner of the display, when the
off-center feature is activated.
Manual off-center
You can move your ship position to the current cursor position on all modes except
true motion, within 75% of the available display area.
1. Put the cursor on the position where to off-center the display.
2. Press the OFF CENTER key.
Custom off-center
You can move your ship position to the position which you preset. Follow the proce-
dure shown below to register the cursor position. The display is off-centered by the
amount set here, when you activate the off-center function.
Note: [Off-center mode] must be set as [Custom]. See section 2.23.1.
1. Turn off the off-center display and put the radar in transmit (TX) mode.
Off-centered displayPut cursor where desired
and do appropriate
off-center procedure.
Cursor
Cursor
To Next Page
Loading...
Need help?
General
