1. OPERATIONAL OVERVIEW
1-25
1.15 Man Overboard (MOB)
The MOB mark denotes man overboard position. Enter the mark when someone falls
overboard, to automatically create a route to the man overboard position. Only one
mark can be displayed.
1.15.1 How to mark MOB position
Long-push the EVENT/MOB key on any screen. The plotter display appears if you are
using a different screen. The MOB mark is put at the latitude and longitude position of
your boat at the moment the key is pressed. The [MOB] box at the bottom left of the
screen shows the bearing and range to the MOB mark.
1.15.2 How to stop navigating to a MOB mark
Put the cursor on the MOB mark then press the ENT key. “STOP” appears at the bot-
tom left corner. Press the ENT key to stop navigation. The message "Stop navigating
to MOB. Are you sure?" appears. [YES] is selected; press the ENT key.
1.15.3 How to erase an MOB mark
Put the cursor on the mark then press the ENT key to show the context-sensitive
menu. Select [DELETE] then press the ENT key. The message "Delete MOB. Are you
sure?" appears. [YES] is selected; press the ENT key. (The MOB mark set as desti-
nation cannot be erased. You must cancel navigation to the mark before you can
erase it.)
1.16 How to Take a Screenshot
You can take a screenshot at any time and save it to the internal memory, in PNG for-
mat. Open the full RotoKey menu then select [Screenshot]. The internal memory can
hold up to 60 screenshots. For how to process screenshots, see section 9.8.
MOB mark
MOB
180°T
14.2 NM
MOB box
Bearing to MOB position
Range to MOB position
To Next Page
Loading...
