1. OPERATIONAL OVERVIEW
1-10
Note: You can return the value to zero by pressing the CLR FLD soft key.
8. Enter SPEED, DATE and TIME.
9. Rotate the [ENTER] knob to choose CURSOR CONTROL and then push the
[ENTER] knob.
10. Rotate the [ENTER] knob to choose On or Off as appropriate and then push
the [ENTER] knob.
When On is selected, you can set course value (◄ ►) and speed value (▲ ▼)
on the plotter display.
11. Rotate the [ENTER] knob to choose SELECT POSITION and then push the
[ENTER] knob.
The plotter display appears.
12. Operate the cursor pad to place the own ship marker at the desired starting
point.
13. Push the [ENTER] knob.
14. Press the [CLEAR] key.
To Next Page
Loading...
