4. WAYPOINT
4-3
4.1.2 Entering a waypoint from the waypoint list
You can manually enter waypoint position from the waypoint list as follows.
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose PLOTTER and then push the [ENTER]
knob to show the PLOTTER menu.
TRACK
ROUTES
WAYPOINTS
MEMORY CARD
TRACK 11999/12000
WAYPOINTS 12/2000
Number of tracks and waypoints in use
Plotter menu
3. Rotate the [ENTER] knob to choose WAYPOINTS and then push the
[ENTER] knob.
The WAYPOINT LIST is displayed.
WAYPOINT LIST
SYM TYPE
MODE
DST [nm}
BRG [M]
LATITUDE
LONGITUDE
ICON SEARCH PLOT EDIT NEW
MODE DELETE SORT SEND RECEIVE
NAME
COMMENT
0001WP
00:58 MAY3104
WPT
34 34. 641 N
135 09. 912 E
6.669
045
SHOWN
Waypoint list
4. Rotate the [ENTER] knob to choose NEW at the bottom of the screen and
then push the [ENTER] knob.
The new waypoint is entered at the current own ship position. (When cursor is
turned on, it is entered at the cursor position.)
5. If desired, change waypoint data; choose EDIT (at the bottom of screen) and
follow the paragraph 4.2.
6. Press the [CLEAR] key to close the WAYPOINT LIST.
Note 1: The WAYPOINT LIST can also be shown by pressing the WPT/QWP
LST soft key, which is shown when the cursor is placed on a waypoint.
Note 2: You can change the page of the WAYPOINT LIST by pressing ◄ or ►.
To Next Page
Loading...
