Furuno GS-100 - User Manual

Questions and Answers

S
Steven McneilJul 30, 2025
Why are data not transmitted to external equipment on my Furuno Boating Equipment?
- K
  Karen EdwardsJul 31, 2025
  If data is not being transmitted to external equipment, verify the data format in the [5 I/O] menu is correct. Ensure the TX interval is properly selected and not set to off. Check the settings on the external equipment and verify the connections. Connect the TD-A of the GS-100 to the RD-A of the external equipment, and the TD-B of the GS-100 to the RD-B of the external equipment.
H
helenbryantAug 3, 2025
What to do if my Furuno Boating Equipment position is not fixed?
- D
  Deborah IrwinAug 3, 2025
  If the position is not fixed, check that the antenna connector is firmly fastened. Also, check the number of satellites on the integrity display. If there are two or less, check for obstructions between the antenna unit and satellites.
V
valentinemarkAug 8, 2025
What to do if my Furuno Boating Equipment position is wrong?
- S
  scottbakerAug 8, 2025
  If the position is wrong, verify that the correct geodetic chart system is selected on the [7 System Setting] - [1 System] - [3 Datum] menu.
C
Chelsea JonesAug 12, 2025
How to troubleshoot heading output stops on Furuno GS-100 Boating Equipment due to antenna location?
- S
  Shannon WardAug 12, 2025
  If the heading output stops, check the antenna location and for any interfering objects nearby. Also, inspect the installation site and mounting base for vibration. Check for any nearby radar or radio equipment antennas.
J
Joshua MillerAug 16, 2025
What to do if the icon shown in the right appears on the display of Furuno Boating Equipment?
- D
  Douglas JacobsAug 16, 2025
  If the specified icon appears on the display, it may indicate that the SC-30 is installed, in which case you should mount the GS-1001. Alternatively, the antenna vibration frequency may be over 5G; if these icons appear frequently, try changing the antenna location or implement measures against the vibration. Also, the common satellite for antenna 1 and 2 may be blocked, so try changing the antenna location.
P
patriciaperkinsAug 21, 2025
What to do if I cannot turn on the power of Furuno GS-100?
- B
  Brandon RussellAug 21, 2025
  If you cannot turn on the power, check for a damaged power cable and connector. Ensure the power cable is firmly fastened. Check the battery for proper voltage output.
A
Angela RandolphAug 25, 2025
What to do if no picture appears on my Furuno Boating Equipment?
- F
  Frank CharlesAug 26, 2025
  If no picture appears, press the BRILL key followed by the cursorpad (X) to increase the display brilliance.