1. INSTALLATION OF UNITS
1-5
1.3 Rudder Reference Unit FAP-6111
• Leave sufficient space around all moving parts.
• The unit must be coupled to the rudder as shown below, where the following conditions
are satisfied:
Use four tapping screws and flat washers (supplied) to fasten the rudder reference unit with
gasket (supplied).
350 mm < Y2 < 600 mm
X1 = X2
Y1 = Y2
X1
X2
Y1
Y2
90
Top view
Mounting the rudder reference unit
The FAP-6101 may be substituted (for FAP-300/330) instead of the FAP-6111.
To Next Page
Loading...
