Furuno NAVpilot-511 - Mounting the Hunger for FAP-5551;5552; Reversing the Switch and Dial Blocks

1. INSTALLATION OF UNITS
1-7
Dial type remote controller FAP-5551/5552 can also be mounted on the bulkhead by using
the optional hanger OP64-2 (Code No.: 009-004-030).
Mounting the hunger for FAP-5551/5552
For handheld operation in the opposite direction, reverse the switch and dial blocks so that
the dial is readable. To do this, loosen the four screws shown below. Note that the switch
and dial blocks are inserted into the controller body with O-rings. Be careful not to damage
them.
Reversing the switch and dial blocks