1-1
1. INSTALLATION OF UNITS
1.1 Control Unit FAP-5001/5011
The control unit can be flush mounted in a console panel. For the FAP-5001, the desktop
mounting is also available using the optional bracket kit.
FAP-5001
FAP-5011
Control unit
When selecting a mounting location for the control unit, keep the following in mind.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal.
• Use the supplied display hard cover when the system is not in use.
• Do not mount the display unit under “Plexiglas” or any other type of shielding which could
trap heat and moisture or magnify sunlight energy onto the surface of the display.
• For maintenance and checking purposes, leave sufficient space at the sides and rear of
the unit and leave slack in cables.
• A magnetic compass will be affected if the control unit is placed too close to the magnetic
compass. Observe the compass safe distances to prevent disturbance to the magnetic
compass.
FAP-5001: standard: 0.45 m, steering: 0.3 m.
FAP-5011: standard: 0.3 m, steering: 0.3 m
To Next Page
Loading...
