Furuno NAVpilot-511 - Selecting Course after the Remote Mode Is off; Course after Remote Options Window (Ex. Navpilot-500); Course after Remote Controller Is Turned off

3. ADJUSTMENTS
3-18
Selecting course after the REMOTE mode is off
When the remote controller is turned off while in the AUTO mode, the “COURSE AFTER
REMOTE” mode can be chosen as shown below.
1. Rotate the course control knob to select “CSE AFTER REMOTE”, and then press it to
show the course after remote options window.
PRESENT COURSE
PREVIOUS COURSE
Course after remote options window (Ex. Navpilot-500)
PREVIOUS (COURSE): The previous course before using the remote controller.
PRESENT (COURSE): The heading at the moment the remote controller is turned off.
Previous course
New course
Remote
controller: OFF
Remote
controller: ON
PRESENT COURSE mode
Remote
controller: ON
Remote
controller: OFF
Previous course
PREVIOUS COURSE mode
Course after remote controller is turned off
2. Rotate the course control knob to select PRESENT (COURSE) or PREVIOUS
(COURSE) as appropriate.
3. Press the course control knob.