3. ADJUSTMENTS
3-8
3. Rotate the course control knob to select PG-500, PG-1000 or OTHER depending on the
heading sensor connected.
If OTHER is selected though the PG-500 is connected, the auto variation compensation and
self check function is not available. (Use hybrid or gyro sensor only.)
4. Press the course control knob to finish.
3.2.13 Setting compass baud rate
Select the baud rate of the heading sensor connected.
1. Rotate the course control knob to select “COMPASS BAUD RATE”.
2. Press the course control knob to show the compass baud rate options window.
9600
19200
38400
4800
Compass baud rate options window
3. Rotate the course control knob to select the baud rate from among 4800, 9600, 19200
and 38400 bps.
For PG-500, select 4800 bps (default setting).
4. Press the course control knob to finish.
3.2.14 Setting the rudder at the zero position
You can set the rudder position at zero degree tentatively. However, be sure to set the actual
setting on the SEA TRIAL menu on the sea.
1. Rotate the course control knob to select “SET CENTER RUDDER POSITION (RUD.
POS. for Navpilot-511)”.
2. Press the course control knob to show the following window.
APPROX. CENTER RUDDER
AND PUSH ENTER TO SET.
ARE YOU SURE?
YES...PUSH ENTER KNOB
NO....PUSH ANOTHER KEY
3. Turn the helm to set the rudder to the zero degree position.
4. Press the course control knob to finish.
To Next Page
Loading...
