Furuno NAVpilot-511 - 3 Adjustments; How to Access the Installation Menu

3-1
3. ADJUSTMENTS
3.1 How to Access the Installation Menu
Set up the equipment through the installation menu. To access the installation menu, do the
followings:
1. Turn the power on at the control unit.
2. Press the [STBY] ([STBY/POWER] for Navpilot-511) key to go to the STBY mode.
3. Press the [MENU] ([TURN/MENU for Navpilot-511]) key while pressing the [STBY]
([STBY/POWER]) key.
4. Release the above keys when the INSTALLATION menu appears.
INSTALLATION MENU
DOCKSIDE SETUP
SEA TRIAL
DISPLAY SETUP
DATA CALIBRATION
PARAMETER SETUP
SYSTEM SETUP
ALARM MENU
ADJUST RUD REF. UNIT: NO
RUDDER TEST: NO
SET CENTER RUDDER POS: NO
AUTO TUNING: NO
COMPASS CALIBRATION: NO
"DONE" is shown when
setting is completed.
DOCKSIDE SETUP
SEA TRIAL
DISPLAY SETUP
DATA CALIBRATION
MESSAGE
PARAMETER SETUP
SYSTEM SETUP
ALARM SETUP
CONTRAST/BRILLIANCE
ADJUST RUD REF. UNIT: NO
RUDDER TEST: NO
SET CENTER RUDDER POS: NO
AUTO TUNING: NO
COMPASS CALIBRATION: NO
Navpilot-500 Navpilot-511
INSTALLATION MENU
Installation menu
The installation should be done in the order in which the items of the installation menu are
listed.