2. INITIAL SETTINGS
2-6
[Advanced Diagnostic Test]
[ROM] Shows the test results for each item (OK or NG (No
Good)).
Note: This test automatically checks each item and
data output stops during the test.
[RAM]
[Rate Gyro Test]
[Accelerometer Test]
[GNSS 1 RAM Test]
[GNSS 1 ROM Test]
[GNSS 2 RAM Test]
[GNSS 2 ROM Test]
[GNSS 3 RAM Test]
[GNSS 3 ROM Test]
[GNSS 4 RAM Test]
[GNSS 4 ROM Test]
[Reset Setting]
[Menu Settings] Select [YES] to restore
all user set menu settings
to their default.
Reboot the SCX-20 to
complete the procedure.
Note: Almanac data is
also reset with this proce-
dure, correct positioning
will not be available until
sufficient satellite data is
re-obtained.
[Factory Reset] Select [YES] to restore
the SCX-20 to factory de-
fault.
Reboot the SCX-20 to
complete the procedure.
[Restart]
[System Restart] Select [YES] to restart the SCX-20.
Note: All data output from the SCX-20 stops when
[YES] is selected. This procedure should only be
done when safely moored.
Menu item Description
To Next Page
Loading...
