2. WIRING
2-6
3. Pass DVI-D, VIDEO, AUDIO and/or USB cables through the fixing metal (sup-
plied).
Orient the fixing metal as shown below.
4. Attach each connector to the appropriate location at rear of the equipment
5. Pass cables through the slit on the boot cover.
6. Pass cables through appropriate holes in the rubber stopper. The largest hole is
for the DVI-D cable.
7. Use four binding screws (M3x10, supplied) to fasten the fixing metal and boot cov-
er to the equipment.
Upward
Rubber stopper
Cables
Binding screw (M3x10, 4 pcs.)
Connectors
Boot cover
(The side with projection should be downward.)
Rubber stopper
Fixing metal
To Next Page
Loading...
