Fusion MS-IP700i

53
To enable or disable the AM of VHF tuner sources:
1. Press the Menu key.
2. TurnandthenpresstheEncodertoselecttheSettings > Sources.
3. Ifrequired,presstheEncodertoenabletheAMsource( )ordisable
the AM source ( ).
4. Ifrequired,turntheEncodertoselectVHF then,presstheEncoderto
 enabletheVHFsource( )ordisabletheVHFsource( ).
5. Press any key to exit.
Set Aux name
Select `Set Aux name’ to give the AUX input a name that is more
representative of the device connected to the AUX input. Select a name from
the available list. The name is displayed on the AUX Source screen along with
a matching graphic.
Accessory (Shared BT-200 Bluetooth & SiriusXM Source)
If you have installed the MS-BT200 Bluetooth module or SiriusXM Tuner (USA
Only)youwillneedtoenablethesource.Thisoperationwillbedeterminedby
the Tuner region you have selected.
Tuner Region - USA
When USA Tuner region is selected, press the menu button and select
Settings>Sources>AccessorythenselectthesourcetoenableSiriusXMor
Bluetooth.
TunerRegion-Australasia-Europe-Japan
In these Tuner regions once the MS-BT200 is installed and connected the
source will be available.
Set device name
Select `Set Device Name’ to give the Stereo a network name of your choice.
Thenameisvisibletootherdevices(MarineWiredRemotesMS-NRX200i)
connectedtothesameFUSIONnetwork.Rotatetherotaryencoderto
change the character. Press the rotary encoder to select. Press the `Previous’
button to delete characters. · To save changes press the `Play’ key. · To exit
without saving any changes: press the Menu key.
About
This option displays the Stereo software version, remote control version and
FUSION-Link software versions.