12
Assembly / Adjustment
As you connect the receiver, servos and other components, do so in accordance with the
"Assembly Precautions".
Install the R203GF/R304SB/R314SB receiver on the car as follows:
Note: The operating range may become shorter, depending on where the
receiver and the antenna are mounted.
Install the antenna in the higher place as shown in the figure.
Keep the antenna as far away from the motor, ESC and other
noise sources as possible.
Put the antenna in the antenna tube to protect it.
Do not cut the antenna.
Do not bend the coaxial cable. Doing so causes damage.
Antenna
tube
Antenna
Coaxial
cable
Receiver
Receiver and Servo Connection
Receiver Antenna Installation
$&%
B/C
CH3
CH2
CH1
CH4
Receiver
Switch
To Battery
CH4 servo
CH3 servo
Throttle servo
Steering servo
Installation When An Electronic Speed Control Is Used
Installation For Gas Powered Models
e.g. R314SB
e.g. R314SB
To Next Page
Loading...
