FUTABA 3pv-2.4g - Mixing and Servo Reversing; 4 WS and Brake Mixing Setup; Servo Reversing Functions

20
Either 4WS mixing function or
Brake mixing function can be
selected on this screen.
*This function can't be used in R203GF.
4WS/BRK Mixing

SMX

4WS Mixing (4WS)
This mixing is used with Crawler and
other 4WS specification cars. The 1st
channel controls the front side steering
and the 4th channel controls the rear side steering.
• 4WS function selection
1. After connecting the linkage, use the servo reverse function to change the
direction of operation of the front and rear wheels.
2. Thereafter, use the end point adjuster to adjust the left and right steering
angles.
Brake Mixing (BRK)
Use this mixing when the front and rear brakes must be adjusted independently, such as in 1/5GP cars, etc.
This mixing uses the 2nd channel to control the rear brakes and the 4th channel to control the front brakes.
• When braking, mixing is applied to 2nd channel and to 4th channel.
• The set value of A.B.S. function is reected.
Steering Servo Reversing

REV-CH1

Throttle Servo Reversing

REV-CH2

Channel-3 Servo Reversing

REV-CH3

NOR: Normal
REV: Reverse
Steering Servo Reverse
Direction change
Throttle Servo Reverse
NOR: Normal
REV: Reverse
Direction change
Channel-3 Servo Reverse
NOR: Normal
REV: Reverse
Direction change
This function reverses the rotation
direction of the Steering servo.
This function reverses the rotation
direction of the throttle servo.
This function reverses the rotation
direction of the channel-3 servo.
When the trim position deviates from the
center, the deviation will be on the opposite
side when the servo is reversed.
When the trim position deviates from the
center, the deviation will be on the opposite
side when the servo is reversed.
INH: Inhibited
4WS: 4WS mixing
BRK: Brake mixing for second brake
Special Mixing Selection
Mixing change
CH1
CH4