FUTABA 4PK 2.4GHZ - Mechanical ATL Adjustment; Wheel & Trigger Tension Adjustment

Mechanical ATL
adjusting screw
18
Before Using
Adjustment
1
 5SING AMM HEX WRENCH ADJUST THE TRIGGER
brake (reverse) stroke. (The screw moves the
throttle trigger stopper.)
s7HEN THESCREWISTURNEDCLOCKWISETHE STROKE BECOMES
NARROWER!DJUSTTHESTROKEWHILEWATCHINGTHESCREW
Note:
Mechanical ATL Adjustment
Make this adjustment when you want to decrease the stroke of the brake (back) side of
the throttle trigger for operation feel.
Wheel & Trigger Tension Adjustment
Make this adjustment when you want to change the wheel or trigger spring’s tension.
Adjustment
1
5SINGAMMHEXWRENCHADJUST
the wheel spring tension by turning
THESCREWINSIDE THE ADJUSTING HOLEIN
the arrow direction.
s4HE SPRING IS SETTOTHE WEAKESTTENSION ATTHE
factory.
s7HEN THE ADJUSTING SCREW IS TURNED CLOCKWISE
the spring tension increases.
Note:
Wheel tension
adjusting screw
Once you have changed the mechanical stroke on the brake side, be sure to adjust
the scale of the throttle channel accordingly by using the "Adjuster Function"
(page 114).
Due to this change, you also need to adjust in most cases the travel of the throttle
servo by using "Data Setting."
The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) posi-
tion. If turned further than this, the adjusting screw may fall out.
Trigger tension
adjusting screw