FUTABA 4PK 2.4GHZ - Digital Trim Operation; Grip Dial Operation

Steering trim display
Throttle trim display
Steering D/R DL1
ATL DL2
ATL display
Steering D/R
display
DT2 DT3
DT1
17
Before Using
Trim Operation
Digital Trim Operation
(Initial settings: DT1: Steering trim, DT2: Throttle trim, DT3: -------)
Digital trims can be used in 2 ways:
Operating by the lever: Push the lever to the left or right (up or down) Operating by push
button switch: Press the push button switch in the desired direction. The current position
is displayed on the LCD screen in the bottom three rows of the list. However, this opera-
tion cannot be performed when the trim/dial lock (p.22) function is set.
s%ACHSTEPISINDICATEDBYATONE
s7HENTHETRIMEXCEEDSTHEMAXIMUMTRIMADJUST-
ment range, the beep will change and the servo
will not move any farther. Return to the neutral
position (center) by pressing both the push button
switches simultaneously for about one second.
s4RIMLEVERADJUSTMENTSHAVENOEFFECTONTHEMAXI-
mum servo travel.This prevents the linkages from
BINDINGWHENADJUSTMENTSAREMADE
Grip Dial Operation
(Initial setting: DL1; Steering D/R, DL2; ATL)
Operate the dials by turning them. The current set value is displayed on the LCD screen.
However, this operation cannot be performed when the trim/dial lock (p.22) function is set.
s%ACHSTEPISINDICATEDBYATONE
s7HENTHETRIMEXCEEDSTHEMAXIMUMTRIMADJUSTMENTRANGETHETONEWILLCHANGEPITCHANDTHESERVOWILLNOT
move any farther.
With the center trim feature, trim adjustments have no effect on the maxi-
mum servo travel. This prevents the linkages from binding when adjust-
ments are made.