FUTABA 4PK 2.4GHZ - Charging the HT5 F1700 B Battery

ｎ
Caution
ｎ
Warning
AC outlet
Charger
Transmitter charging
LED
To transmitter
charging jack
To receiver
Ni-Cd battery
20
Before Using
Over current protection
Charging
jack
Cover
The transmitter charging circuit is equipped with an over cur-
rent protection circuit (1.7A). If the battery is charged with a
quick charger for other than digital proportional R/C sets, it
may not be fully charged.
When charging the HT5F1700B battery with the special char-
ger, allow about 15 hours for charging. If the transmitter has
not been used for some time, cycle the battery by charging
and discharging it two or three times.
ｌ
Never plug it into an outlet other than indicated voltage.
0LUGGINGTHECHARGERINTOTHEWRONGOUTLETMAYRESULTINANEXPLOSIONSPARKINGORlRE
ｌ
Do not insert and remove the charger when your hands are wet.
It may cause an electric shock.
ｊ
Always use the special charger or a quick charger for digital proportional R/C sets to charge a
digital proportional R/C set Ni-MH battery.
/VERCHARGINGA.I-(BATTERYCANRESULTINBURNSlREINJURIESORLOSSOFSIGHTDUETOOVERHEATINGBREAKAGEORELECTRO-
lyte leakage.
ｌ
Never try to recharge a dry cell battery.
The transmitter may be damaged or the battery electrolyte may leak or the battery may break.
ｊ
When the charger is not in use, disconnect it from the AC outlet.
Do this to prevent accidents and to avoid overheating.
Charging
1
Plug the transmitter cord of the special char-
GER INTO THE CHARGING JACK ON THE REAR OF THE
transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
Charging The HT5F1700B Battery
The HT5F1700B is 5-cells, so, when charging the HT-
5F1700B battery with Futaba CR-2000 charger, you have to
use the RX output side.
When using Futaba CR-2000