FUTABA 4PK 2.4GHZ - Trigger Slide Adjustment; Ni-MH Battery Replacement

ｎ
Caution
Battery cover
While pressing here Battery cover
19
Before Using
Ni-MH Battery Replacement
The Ni-MH battery is connected by a Futaba J connector so that it can be removed when
you will not be using the transmitter for a long time, or when replacing a dead battery
with a spare battery.
s!LWAYSUSEAN(4&"BATTERY
Removal
1
Slide the transmitter battery cover in the ar-
row direction while pressing the part shown
in the figure.
2
Remove the Ni-MH battery and disconnect
the connector.
3
Insert the connector of the new battery and
load the battery into the transmitter.
4
Finish by installing the battery cover.
ｊ
Pay full attention so that the battery cover
deas not pinch the cable of the Ni-MH battery.
Pinching the cable by the battery cover can lead to an
electrical shortage, fire and abnormal heat generation,
which may cause burns and fire disaster.
Trigger Slide Adjustment
The throttle trigger position can be moved forward and backward.
Adjustment
1
5SINGAMMHEXWRENCHLOOSENTHE
trigger slide mounting screw by turning it
slightly counterclockwise.
2
5SINGAMM HEXWRENCHTURNTHE TRIG-
GERSLIDE ADJUSTING SCREW AND ADJUST THE
trigger slide position within the marked
RANGE7HENTHEADJUSTINGSCREWISTURNED
clockwise, the trigger slide moves away
from the grip handle.
3
Retighten the mounting screw loosened at
step 1 and fasten the trigger slide
Trigger slide adjusting screw
Adjust so that the bottom
mark does not exceed
the top marking line.
Trigger slide
mounting screw
Install the cover by aligning the claws at both sides
of the battery cover with the grooves in the trans-
mitter shown in the figure and sliding on the battery
cover.