FUTABA 4PK 2.4GHZ - Functions; Receiver Type;Servo Response Mode RXSYS

46
Function
(Opening Screen)
MENU 1
Press t
he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t
he button
* When the direct call button
is set, the setup screen is also
called by the following method:
s3ELECTTHESETTINGITEMBY
button
*
blinks at the current
setup item.
Function
Receiver Type / Servo Response Mode "RXSYS"
Receiver Type/Servo Response Mode RXSYS
Receiver
There are two types of Futaba 2.4GHz receivers for cars depending on the system dif-
ferences: C1 type and C2 type. The R603FS and 603FF are C1 type and the R604FS
supplied with the 4PK set as standard is C2 type. For the R603FS and 603FF, set RX
TYPE to
"
FASST-C1
"
and for the R604FS, set RX TYPE to
"
FASST-C2
"
.
-
When the receiver type and servo response was changed
and when a model of a different receiver type and servo
response was selected, turn the transmitter power off and
on. Radio waves are output by the type set at that point.
RX TYPE
FASST-C1, FASST-C2
RESPONSE
HIGH SPEED (BLS DIGI)
NORMAL (GENERAL)
(Preparation)
Select the item to be set by (JOG) button up or down opera-
tion.
1
(Writing to memory)
Press the (+) or (-) button and set the RX TYPE or RESPONSE.
2
In order the change to occur you need to cycle the power (off/
on) to make the change successful.
Rx type / Servo response mode selection
RX TYPE / RESPONSE selecrion
- Select by (JOG) button left or
right operation.
Select button
- Select with the (+) or (-) but-
tons.
HIGH SPEED or NORMAL servo response mode can be selected. However, the HIGH
SPEED mode is for Futaba digital servo (including BLS Series brushless servos) use
only. When using another servo, select the NORMAL mode. All servos, including digi-
tal servos, can be used in the NORMAL mode.
Servos
Mode currently operating.
Mode currently set in memory.