95
(2) WRITE
Write the data set with GPB - 1 to the connected S.BUS
servo. Move the cursor to "WRITE" by pressing the
[
/+] or [ /-] key. Press the [Enter] key to enter the
writung mode. When "EXECUTE: Enter (1
sec)" is dis-
played, press and hold the [Enter] key for about 1 sec-
ond. To cancel, select press [Enter] key or [Esc/Page]
key to exit the recall mode.
- "COMPLETED
!" is displayed on the screen and the set-
ting data is written to servo.
- If "FAILED" is displayed on the screen, repeat [WRITE] or
turn the power off and confirm the connection, then turn
the power on and perform the operation again.
(3) INIT.
Write the factory set servo setting data to the con-nect-
ed servo. Move the cursor to "INIT" by pressing the [
/+] or [ /-] key. Press the [Enter] key to enter the writung
mode. When "EXECUTE: Enter (1
sec)" is displayed,
press and hold the [Enter] key for about 1 second. To
cancel, select press [Enter] key or [Esc/Page] key to exit
the recall mode. The setting of the channel setting and
servo type (760
us / 1520
us) is not initialized.
- "COMPLETED
!" is displayed on the screen and the initial-
ize a setting data is written to servo.
- If "FAILED" is displayed on the screen, repeat [INIT] or
turn the power off and confirm the connection, then turn
the power on and perform the operation again.
Press the [Enter] key
Press the [Enter] key
Press and hold
the [Enter] key
Press and hold
the [Enter] key
To Next Page
Loading...
