FUTABA FX-36 - Page 115

115
＜ Linkagemenu ＞
When using at the teacher side
1. Select the mode.
*When changing the mode, tap to the item you want to
change and change the mode using the "źź" "ź" "Ÿ"
"ŸŸ" buttons. The display blinks. Tap the screen to change
the mode.
"Teacher/Student": Select [Teacher].
"ACT/INH": Enable operation by changing to
[OFF] or [ON].
"16/12/8 CHANNEL": When the student uses
the FX-36 (including the T18M=,T18S=,T16S=,
T14SG) select [16CH]. Otherwise select [12CH]
or[8CH].
2. Select the trainer switch.
*When setting or changing the switch, tap to the "SWITCH"
item, call the switch setup screen and set the desired switch
and ON/OFF direction.
(See "Switch selection method" at the end of this
manual for selection method details.)
*The switch mode can also be selected when setting the
ON position on the switch setup screen. When [Normal] is
selected, normal ON/OFF operation is performed. When
[Alternate] is selected, the trainer function is alternately
turned on and off each time the switch is operated. This
allows alternate ON/OFF switching even when a momentary
switch (SH) is used.
Note: The trainer function won·t be turned
on unless the Instructors transmitter receives
signals from the students transmitter. Be
sure to confirm this after connecting your
trainer cable.
When using at the student side
1. Select the mode.
*When changing the mode, tap to the item you want to
change and change the mode using the "źź" "ź" "Ÿ"
"ŸŸ" buttons. The display blinks. Tap the screen to change
the mode.
"Teacher/Student": Select [Student].
"ACT/INH": Enable operation by changing to
[ACT].
"16/12/8 CH": When the student uses the FX-
36,T14SG,T18S=,T16S=,T18M=, select [16CH].
When the student uses the T14M=, T12=, T12FG
or FX-40, select [12CH]. Otherwise select
[8CH].
Note: In "student mode", only the teacher
side can turn on and off the power to the
students transmitter. .eep the power switch
always at off position.
ŏ Tap the [Trainer] button in the Linkage menu to call
the setup screen shown below.
ŏReturn to Linkage menu