FUTABA FX-36 - Page 26

26
＜ BeforeUse ＞
Stick
Switch
SI
SJ
1.PP he[aJRnaO Zrench
8se the attached .mm hexagonal wrench
to turn the screw clockwise to adjust the stick
outwards or counter-clockwise to tilt it inward.
1ote: %e careful not to turn the screw too far
counterclockwise as it could fall out.
Hardware select of each function
ŤƇƍƘƖƗƐƈƑƗŃƒƉŃƗƋƈŃƖƗƌƆƎŃƏƈƙƈƕŃ
ƄƑƊƏƈ
<ou can make fine adjustments to the angle of
a stick lever either inwards or outwards from the
center stick position.
ŷƋƕƒƘƊƋŃƋƒƏƏƒƚŃƖƗƌƆƎŃƏƈƙƈƕ
:hen the optional stick switch is connected
to the inside accessories connector SI - S- the
switch SI - S- becomes usable.
Toinsideaccessories
connectorSJ-SI
*2ption not included
Cable inlet
thrRXJh the
hRllRZ sticN
leYer