FUTABA FX-36 - Page 27

27
＜ BeforeUse ＞
Modi¿cation to ratchet system
:hen modifying the throttle stick from self-
neutral system factory installation to ratchet
system use the accessory parts to change the
corresponding switch to the mode Mode  or
Mode 2 used.
>Modi¿cation@
1. 7Xrn RII the pRZer tR the transPitter.
. Open the rear case anG rePRYe the battery.
6ee >,nstallinJrePRYinJ the 5ear case@.
. 8se the accessRry 1.PP he[aJRnal Zrench
tR rePRYe the tensiRn aGMXstinJ screZ.
*This screw is used only when returning to the self-neutral
system. Save it.
. )asten the accessRry sZinJ arP stRpper Zith
the set screZ as shRZn in the siGe GiaJraP.
7his Irees the thrRttle sticN.
*/ock the stick at the low side or high side by some method
so that the stick swing arm does not rise when installing the
stopper.
*Insert the stopper so that the swing arm is not returned by
the spring. Align the notch of the stopper to the spring.
1e[t aGMXst it tR the tensiRn yRX preIer.
ŤƇƍƘƖƗƐƈƑƗŃƒƉŃŷƋƕƒƗƗƏƈŃŶƗƌƆƎŃŋŵƄƗƆƋƈƗŃŶƜƖƗƈƐŌ
<ou can choose either airplane ratchet system or helicopter-touch.
Mode2/4Mode1/3
Swingarmstopper
Setscrew
Swingarm
Includedinset