FUTABA FX-36 - Page 32

32
＜ BeforeUse ＞
ŵŚœœśŶť ŦūŃŰƒƇƈ
The RS% receiver is a very versatile
unit. It has  P:M outputs S.%8S and S.%8S2
outputs. Additionally the P:M outputs can be
changed from channels - to channels -6. If
you only desire to use it as an  channel receiver
without S.%8S it can be used without any
setting changes.
The FX-36 has the ability to link to two
RS% receivers. 2ne of them outputting
channels - and the other outputting channels
-6 gives you 6 P:M channels. Instructions
for this configuration and S.%8S operation
follow.
>How to change the RS% Channel mode.@
1. 3ress anG hRlG GRZn the /inN0RGe bXttRn
Rn the 56% receiYer.
. 7Xrn the receiYer Rn Zhile hRlGinJ GRZn
the /inN0RGe bXttRn. :hen the /('
beJins tR blinN JreenreG the bXttRn Pay
be releaseG.
. 7he /(' shRXlG nRZ be blinNinJ reG in Rne
RI the patterns G
escribeG by the chart
belRZ.
. (ach press RI the 0RGe/inN bXttRn
aGYances the receiYer tR the ne[t PRGe.
. :hen yRX reach the PRGe that yRX Zish
tR Rperate in press anG hRlG the 0RGe
/inN bXttRn IRr PRre than  secRnGs.
. Once lRcNeG intR the cRrrect PRGe the
/(' Zill chanJe tR a s
RliG cRlRr.
. 3lease cycle the receiYers pRZer RII anG
bacN Rn aJain aIter chanJinJ the Channel
0RGe.
Receiver
connector
Settingchannel
ModeA
1-8CH
ModeB
1-7CH
ModeC
9-16CH
ModeD
9-15CH
1 1199
2221010
3331111
4441212
5551313
6661414
7/B 7 7 15 15
8/SB 8 S.BUS 16 S.BUS
RedLEDblink 1time 2times 3times 4times
R7008SB CH MODE TABLE
DANGER
Don'ttouchwiring.
*Thereisadangerofreceivinganelectricshock.
Donotshort-circuitthebattery
terminals.
*Ashortcircuitacrossthebatteryterminalsmay
causeabnormalheating,fireandburns.
Pleasedoublecheckyourpolarity
( ＋ and − )whenhookingupyour
connectors.
*If＋and −ofwiringaremistaken,itwilldamage,
igniteandexplode.
Don'tconnecttoExtraVoltagebefore
turningonareceiverpowersupply.
Default