FUTABA FX-36 - Page 92

92
＜ Linkagemenu ＞
Sensor：Reload
ŏ Call page 3/3 from the [Sensor] menu.
Thispageissetwhenusingmultipletelemetrysensorsofthesametype.
When using multiple sensors of the same type
the sensors must be registered in the transmitter.
Connect all the sensors to be used to the FX-36 as
shown in the ¿gure at the right and register them by
the following procedure. The ID of each sensor is
registered in the transmitter.
);
Hub
Hub Hub
SENSOR SENSOR SENSOR SENSOR SENSOR
Reading all the sensors to be used
1. Connect the sensor to the FX-36 as shown in the Àgure above.
2. Tap ´Reloadµ on page 3/3 of the [Sensor] screen.
3. Tap ´Reloadµ.
All the sensors are registered and can be used.
*It is not necessary to carry out
multiple battery connections like
a T18M=/T14SG.
Sensor:Register
Thispageissetwhenusingmultipletelemetrysensorsofthesametype.
This function registers an additional sensor.
Connect the sensor as shown in the figure at the
right and register it by the following procedure.
The sensor ID is registered in the transmitter.
);
SENSOR
Additional sensor registration
1. Connect the sensor to the FX-36 as shown in the figure
above.
2. Tap ´Registerµ on page 3/3 of the Sensor! screen.
3. The sensor is registered and can be used.
*When the number of slots needed in
registration is insufficient, an error is
displayed and registration cannot be
performed. Disable unused slots or
perform the following reload.
ŏ Call page 3/3 from the [Sensor] menu.
ŏReturn to
Linkage menu
ŏReturn to
Linkage menu
*It is not necessary to carry out
multiple battery connections like
a T18M=/T14SG.