FUTABA FX-36 - Page 93

93
＜ Linkagemenu ＞
*For some transmitters (e.g., T6K), when the start slot of a
sensor is changed, the sensor cannot be used.
WARNING
This procedure changes the slot number of one
registered sensor.
Sensor slot change
1. Connect the sensor to the FX-36 as shown in
the Àgure above.
2. Tap ´Change slotµ on page 3/3 of the
Sensor! screen.
3. Tap ´Readµ.
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a
＋
Ɇ

button, tap.
（
Cannot be
set to a slot that cannot be allocated like the
table of all pages.
）
6. Tap to the ´Writeµ.
Sensor:Changeslot
Thispageissetwhenusingmultipletelemetrysensors
ofthesametype.
);
SENSOR
ŏ Call page 3/3 from the [Sensor] menu.
ŏ Tap the [Change slot] button
in the Sensor screen to call the
setup screen shown below.
ŏReturn to
Linkage menu
Donotdisconnectorturntransmitter
powerOFFwhiletelemetrysensordata
isbeingsaved.
Sensorsavedatawillbelost,resultingin
malfunction.
*It is not necessary to carry out
multiple battery connections like
a T18M=/T14SG.