77
(6) ACC Gain: F/F mixing acceleration gain
In low head speed situations where a lot of F/F Mixing might be needed,
acc. gain boosts the input and removes it immediately after to help cure
the sudden change in torque, but it does not allow the large tail rotor
input to alter the axial behavior of the helicopter.
Setting ranges: 0 ~ 200% Initial value: 0%
(7) Tail Resp: Tail response
The goal is to match the response between the helicopter tail response and
the gyro control. This feature is utilized to do so. 1 is the fastest response.
Generally, if the tail response is slow or the servo's speed is slow, setting the
tail response setting late will increase the gyro sensitivity and improve the
control performance. Also, if the response setting is delayed, the power con
-
sumption of the servo will be reduced. However, if the response setting is too
late, the operation cannot keep up with high-speed operation of the helicopter.
Setting ranges: 1 ~ 5 Initial value: 1
RUD. EXPERT screen 5/5
Go to 1/5 from any
cursor position
From 4/5
Go to the menu title of RUD. EXPERT screen 1/5
(8) RESET : Rudder gyro data reset
This resets the "RUD.EXPERT" setting back to the defaults. Move the
cursor to "RESET" by pressing the [
/+] or [ /-] key, and press the [En-
ter] key to enter the reset mode. When "EXECUTE: Enter (1
sec)" is
displayed, press and hold the [Enter] key for about 1
second to initialize
"RUD.EXPERT" setting. If you do not wish to reset, press [Enter] key or
[Esc/Page] key to exit the reset mode.
To Next Page
Loading...
Need help?
General
