FUTABA T18SZ Manual

7
T18SZ Model Data Converter
[Substitute hardware function]
* The Futaba Model Data Converter can substitute hardware if the intended transmitter is
not equipped with the same items. For example, if the source code transmitter utilized
an "RST" designation, the converted data may be replaced by "RS" if the destination
transmitter does not utilize the "RST " designation but uses "RS" instead.
* If the intended transmitter does not utilize the same hardware, the initial value of the
hardware is set to NULL.
* The substitution of switch hardware and the linear hardware is not possible.
- Switch hardware …SW-A, SW-B, SW-C, SW-D, SW-E, SW-F, SW-G, SW-H
- Linear hardware …LD, RD, LS, RS, J1, J2, J3, J4, T1, T2, T3, T4
,
T5
,
T6
5. Data conversion
5.1. Click the "Convert" button.
5.2. If successful a dialog box, as shown below, will appear. Please click the "OK"
button.

FUTABA T18SZ Specifications

General

Channels	18
Frequency	2.4GHz
Telemetry	Yes
Modulation	FASSTest, FASST, S-FHSS, T-FHSS
Display	Color LCD
Model Memory	30