3. Place the snap clip back into the frame front to
secure the caster assembly to the frame.
Ensure the hole used by the snap clip is at the
same position on both sides such that the
frame is straight and not at an angle.
4. Remove the two snap clips located on the
frame back
5. Adjust the position of the caster assembly to
the same position as the front casters and hold
the casters in place.
6. Place the snap clips back into the frame back
to secure the caster assembly to the frame.
Ensure the hole used by the snap clip is at the
same position on both sides such that the
frame is straight and not at an angle.
Note: When the height of the commode is changed one
must ensure that the commode is stable and that
one wheel is not higher or lower than another which
could cause problems for the end user.
To Next Page
Loading...