7 CASTERS
590 REV02 REV DATE: SEPTEMBER 13, 2013 22 AQUA NT
7 Casters
Adjusting commode seat height Figure 10
WARNING
After ANY adjustments, repair or service and BEFORE
use, make sure all attaching hardware is tightened
securely – otherwise injury or damage may occur.
The Tente casters used on the commode have a
unique locking mechanism which is located in each
wheel. The mechanism allows the casters to be
independently locked in place so that the commode
does not move. In most instances one has to only the
front two casters for the attendant propelled version
and use the rear wheel locks on the self-propelled
version.
Adjusting Commode Seat Height
1. Remove the two snap clips located on the
frame front
2. Adjust the position of the caster assembly to
the desired height and hold the caster
assembly in place.
To Next Page
Loading...