6 POTTY
590 REV02 REV DATE: SEPTEMBER 13, 2013 19 AQUA NT
6 Potty
Removing and Installing Potty Figure 8 Figure 9
WARNING
After ANY adjustments, repair or service and BEFORE
use, make sure all attaching hardware is tightened
securely – otherwise injury or damage may occur.
Removing Potty
1. Turn the commode around so that one can see
the back of the commode and potty.
2. Ensure the wheel or caster locks are engaged
before removing potty.
3. Open one side of the Velcro potty strap located
on the potty receiver.
4. Gently grasp the handle of the potty and slide
the potty out from the potty receiver in a
direction away from the commode.
5. Place the lid on the potty as shown below and
ensure the lid and potty properly assemble
together. The potty lid handle should be
oriented vertical up to ensure that the potty
assembly does not fall when it is picked up.
To Next Page
Loading...