FXP CD-220 VFD - Chapter 5 Software Setting Command; Baud Rate Setting Command; Parity Check Setting Command

SOFTWARE SETTING COMMAND
17 Customer Pole Display CD-220 VFD
CHAPTER 5 SOFTWARE SETTING COMMAND
User can re-set the default configuration by using the following software commands:
5.1 Baud Rate Setting Command
STX 05 B n ETX Change the baud rate
ASCII Format
STX 05 B n ETX STX 05 E N ETX
Dec. Format
[02][05][66] n [03] [02] [05] [49] [78] [03] 49≦n≦51
Hex. Format
[02h][05h][42h] n [03h][02h][05h][45h][4eh][03h] 31h≦n≦33h
Description Change the display communication baud rate. The baud
rate setting can be selected from 9600~115200 bps.
N Baud rate
30h 115200
31h 38400
32h 19200
33h 9600
5.2 Parity Check Setting Command
STX 05 P n ETX Change the parity check
ASCII Format
STX 05 P n ETX STX 05 E N ETX
Dec. Format
[02][05][80] n [03] [02] [05] [69] [78] [03] n=48,49
Hex. Format
[02h][05h][50h] n [03h][02h][05h][45h][4eh][03h] n=30h,31h
Description
n Parity check
30h None parity
31h Even parity