GAC MOTOR GS4 - Page 91

85
4. Operation of systems and equipment
INT: Intermittent wiping*
- If the wiper combination switch is turned
to the
③
INT position, the front wiper will
start wiping intermittently.
- For the models equipped with the auto
wiping function, intermittent wiping mode
 

system.
- Adjust the intermittent wiping speed by
turning the knob
⑦

LO:Lowspeedwiping
- If the wiper combination switch is turned
to the
④
LO position, the front wiper will
wipe at a low speed.
HI: High speed wiping
- If the wiper combination switch is turned
to the
⑤
HI position, the front wiper will
wipe at a high speed.
Front windshield washer system on
- If the wiper combination switch is turned
toward the rear of the vehicle to the
⑥
position, the front washer will start
spraying water and then the front wiper
will start wiping.
- If the wiper combination switch is released
to return to its original position, the front
windshield washer system will be turned
󰀨
two cycles.
- The front wiper will wipe again 6s later
after stopping to remove the remaining
water stains on the windshield.
Rear windshield washer system on
- When the liftgate is closed, if you turn

position
⑧
, the washer will start to
work, after which the rear wiper will work.
- After the rear washer is turned off, the
rear wiper will work for another 2 cycles,
and then work for another 1 cycle after 6 s.
ON: Rear wiper on
- When the liftgate is closed, if you turn the
rear wiper knob to the
⑩
ON position, the
rear wiper will start wiping.
OFF: Rear windshield washer or rear wiper
o󰀨
- If you turn the rear wiper knob to the
⑨
OFF position, the rear windshield
󰀨
wiper will stop wiping.
Front wiper maintenance
- Within 10 s after turning the ignition
switch to the “OFF” position, if you turn
the control lever of the wiper combination
switch to the MIST position and then
quickly release it to return it to the original
position, the front wiper will move to the
highest position and then stop.
NOTE
This function can be activated or deactivated
 
Front Wiper Maintenance” in the AV system.