5. Driving Guide
Hint
• After the car has been parked steadily, you
should first apply the EPB and then put the
shift lever to the "P" position.
•
pplying the EPB may generate running noise,
which is a normal phenomenon.
• If the car is used to pull other vehicles or is
parked on a ramp with larger slope, pull the
EPB button again after the completion of first
parking to ensure the maximum parking force.
● On the slope of 17 %~ 30 %, a clamping will
be performed again 5 minutes later upon the
first application of the EPB. A certain noise is
normal at this moment.
Caution
The parking brake must be applied when parking.
● When the vehicle is in driving process, it is not
allowable to decrease the speed by using EPB
when unnecessary, because the parking brake
only exerts power on the rear wheels, which
can easily cause traffic accidents.
Releasing Static Parking Brake
– Depress the brake pedal when the Start switch
or Ignition switch is in “ON” position.
– Press the EPB button ① to release the parking
brake until the button indicator light and
indicator light on the instrument cluster are off,
which indicates that the parking brake has
been released.
To Next Page
Loading...
