8. Handling of Accident
8.6 Emergency Start
Jumper Cable
If you can not start the engine because of low
battery energy, you can use the jumper cable to
connect with another vehicle’s battery to start the
engine.
Caution
Connect the positive terminals of the batteries
before connecting the negative ones.
– Switch
the Start or Ignition switch to
“OFF/LOCK” position.
– Connect one end ① of the red cable to the
positive electrode (+) of flat battery “A”, and
the other end ② to the positive electrode (+) of
booster battery “B”.
– Connect one end ③ of the black cable to the
negative electrode (-) of booster battery “B”,
and the other end ④ to the engine cylinder
block or the metal component securely
connecting with the engine cylinder block of
the vehicle with flat battery “A”.
– Start the engine of the vehicle with booster
battery and let it idle, and then start the engine
of the vehicle with flat battery until the engine
runs smoothly.
– Once your car runs stably, disconnect the
jumper cable in reverse sequence.
To Next Page
Loading...
