8. Handling of Accident
Warning
• Do not remove the jumper cables until the
Start or Ignition switch is switched off.
● Turn on the air blower and rear windshield
heater in the vehicle with flat battery to
reduce the voltage peak resulting from
removing the cables.
• Place the jumper cables in position to
prevent them from touching other moving
parts.
Warning
battery can explode if you can not use
the jumper cable properly, seriously injuring
anyone nearby.
● Make sure the voltage of the booster
battery is equal to that of the flat battery,
and the capacity of the booster battery is
similar to that of the flat battery. Otherwise,
it may cause explosion.
● Keep open flames away from the battery to
avoid explosion.
● Do not connect the negative cable to the
negative electrode of the flat battery
directly. Make sure there is no static near
the battery. Otherwise, combustible gas
produced by the battery can be ignited by
sparks, causing explosion.
● Do not connect the negative cable to the
fuel system component or brake pipe.
During operation, do not face the battery to
avoid acid burns.
To Next Page
Loading...
