5. Driving Guide
5.1.7 Mecha
nical Parking Brake System*
Apply parking brake
- Pull the handle of mechanical parking brake
up to limit to apply the mechanical parking
brake, when the mechanical parking brake
state is removed.
Release the mechanical parking brake
- Pull the handle of mechanical parking brake
up slightly, press the button ① in front of the
handle, and press the handle to full range to
release the mechanical parking brake.
Warning
Make sure to apply the mechanical parking
brake after parking.
● When the start switch or ignition switch is
in the "ON" position and when the
mechanical parking brake is applied, the
indicator light is on; When the mechanical
parking brake is removed, the indicator
light
is off.
● When the vehicle is in driving process, it is
not allowable to decrease the speed by
using mechanical parking brake, because
the mechanical parking brake only exerts
power on the rear wheels, which can easily
cause traffic accidents.
● It is forbidden to drive the vehicle when the
parking brake has not been completely
separated. Otherwise, it will cause the
overheating of the rear wheel brake, reduce
the braking efficiency, and also cause the
friction lining of rear wheel brake to wear
out prematurely.
To Next Page
Loading...
